The water connections at the rear of the shower originate from the diverter assembly. Connected to that are the two braided Hot and Cold Water supply hoses. These hoses are approximately 1 Mtr long and have 15mm Compression fittings. The end of these hoses should be connected to the Hot and Cold water supply in the property.Ideally you should ensure that you finish your pipework around 1 Mtr from floor level in the corner for corner fitting showers, or in the middle of the shower, if you have purchased a shower that fits against a single wall.
 |
|
|
|
|
|
| User Opinions |
|
| 50% |
 |
50% |
 |
| 2 total votes. |
|
|
| How would you rate this answer? |
|
|
|
