Bathtek 9013 Steam Shower Cabin
The Everglade 1100 is an 1100mm x 1100mm quadrant steam shower cabin. Having all the features of the Everglade 1000, but slightly more roomy inside. The Everglade 1100 shower has a huge 25cm monsoon rain top shower, hand shower and riser, back jets and of course a powerful 3kw steam generator. The Everglade has roof light, and interior LED lights too. The back inside walls of the cabin are dark mirror glass and create a truly luxury feel against the crisp white base and powder coated silver frame. The tub is made from acrylic bonded onto a full stainless steel frame.
Large steam rooms allow the occupant to sit or stand at a comfortable distance from the steam outlet whilst enjoying the steam facilities. In order to offer the same steam facilities but within a smaller shower cabin footprint the location of the steam outlet pod may be close to the occupant. Care must be taken when using the steam function to avoid scalding. Children should NOT use the steam within the product unless under strict adult supervision.
Package sizes:
Carton 1: 1780mm x 90mm x 460mm
Carton 2: 1150mm x 1150mm x 480mm
Carton 3: 1740mm x 130mm x 930mm Carton 4: 1720mm x 300mm x 200mm
Measurements are a guide only.
Package dimensions may change without notification.
Your Delivery:
Your order will be supplied on a Pallet and arrive on a Tail-lift lorry. The delivery will be taken to your door or as close as is possible within access restrictions (narrow gates etc). You are required to inform us of any access restrictions that may affect deliveries to your delivery location, which would require a smaller delivery vehicle. You are asked to check the goods upon arrival and inform us of any damage within 24 hours.
Installation Notes:
Electrical: This steam shower cabin requires 1 x 13amp electrical supply. It comes with a plug and RCD fitted, however we recommend you remove the plug and have the cabin installed to a fused spur. If you have an RCD fitted within your mains board you may also remove the RCD fitted to the unit.
Water: The cabin requires 1 x hot and 1 x cold water supply. The household water pipes should be fed to a point approximately 1 metre off the floor in the corner where the cabin is to be fitted. Balanced water pressure is required, between 1-3 bar. If using a gravity fed system we recommend you use a pump, to provide the required water pressures. Bathtek do not supply pumps. The steam cabin is a freestanding unit and as such we would recommend your fitter does not fit the unit into locations that mean the cabin cannot be moved away from the wall if needed. The couplings on the cabin to connect to your water supply are standard 15mm compression fittings.
Some of our products arrive in large boxes, please ensure that you have enough room to manoeuvre the boxes and their contents to the installation location. Please also consider the space required to construct the shower cabin needs to be sufficient to enable you to move around the whole unit during its assembly, before sliding into position.
