The Avondale is a fully loaded steam shower cabin - huge 25cm monsoon rain top shower, hand shower and riser, back jets and of course powerful 3kw steam generator. The unit has roof light, and interior and exterior LED lights too. The side walls and doors are clear glass. The Avondale also has a built in whirlpool system and the bath even has a padded head rest pillow. Available in a choice of colourways; Storm - dark back panels or Ocean - Pale back glass panels. Both models feature clear glass front and doors, White LED 'Halo' Light and white panel LED lights.
Large steam rooms allow the occupant to sit or stand at a comfortable distance from the steam outlet whilst enjoying the steam facilities. In order to offer the same steam facilities but within a smaller shower cabin footprint the location of the steam outlet pod may be close to the occupant. Care must be taken when using the steam function to avoid scalding. Children should NOT use the steam within the product unless under strict adult supervision.
Package sizes:
Carton 1: 1650mm x 110mm x 800mm
Carton 2: 1550mm x 540mm x 930mm
Carton 3: 1650mm x 130mm x 67mm
Carton 4: 1620mm x 300mm x 210mm
Measurements are a guide only.
Package dimensions may change without notification.
Your Delivery:
Your order will be supplied on a Pallet and arrive on a Tail-lift lorry. The delivery will be taken to your door or as close as is possible within access restrictions (narrow gates etc). You are required to inform us of any access restrictions that may affect deliveries to your delivery location, which would require a smaller delivery vehicle. You are asked to check the goods upon arrival and inform us of any damage within 24 hours.
Installation Notes:
Electrical: This steam shower cabin requires 1 x 13amp electrical supply. It comes with a plug and RCD fitted, however we recommend you remove the plug and have the cabin installed to a fused spur. If you have an RCD fitted within your mains board you may also remove the RCD fitted to the unit.
Water: The cabin requires 1 x hot and 1 x cold water supply. The household water pipes should be fed to a point approximately 1 metre off the floor in the corner where the cabin is to be fitted. Balanced water pressure is required, between 1-3 bar. If using a gravity fed system we recommend you use a pump, to provide the required water pressures. The steam cabin is a freestanding unit and as such we would recommend your fitter does not fit the unit into locations that mean the cabin cannot be moved away from the wall if needed. The couplings on the cabin to connect to your water supply are standard 15mm compression fittings.
Some of our products arrive in large boxes, please ensure that you have enough room to manoeuvre the boxes and their contents to the installation location. Please also consider the space required to construct the shower cabin needs to be sufficient to enable you to move around the whole unit during its assembly, before sliding into position.
